Fast-setting, high-strength, specialty cement-based grout for joint widths from 1-10 mm. Due to a highly dense mortar structure, this cement-based grout provides particular characteristics regarding its mechanical durability and abrasion resistance. Special cements provide a substantially higher resistance to chemical cleaning agents compared to that of conventional cement grouts. This makes them suitable for use in coor-dination with the respective object users and cleaning agent suppliers.
Due to their superb processing characteristics and the fast setting process, washing- out of the joints is avoided.
Servoperl royal schnell can be used in interior, exterior and submersible* applications. It is suitable for grouting ceramic surfaces, in particular stoneware, earthenware and porcelain stoneware in damp and wet areas, as well as heating screeds or drywall dividing walls and areas subjected to heavy use

Use and mix same batches for color consistency. The tile surface, grout joints must be free of any foreign materials. High ridges of adhesive or mortar should be raked out. Any spacers used should be removed. The tile mortar must be fully dry. Mix Servoperl royalschnell with clean, cool water to a free of lumps and homoge-neous consistency. Pour water to in to a bucket and then add powder. To ensure color consistencies use the same water ratio when using multiple bags for the same job. Allow mixture to slake (3-5 minutes), and then remix before using. Apply grout using rubber float in a diagonal direction across the joint lines to prevent the grout from being dragged out of the joints. Go over each area several times to ensure that the grout is fully packed in. Hold your float at 90° angle to the surface of the tile and move it diagonally across the joints. Do not use dried out remains of the grout and dust wet grout joints with dry powder. Do not grout when directly exposed to the sun and where air draft is present. It is recommended to cover freshly grouted areas with Poly/plastic when working on exterior applications or when dealing with non-absorbent tiles/substrates. Test small area to ensure the desired results.

To avoid staining, please observe the following:
Low temperatures delay the setting process of the mixture, which can lead to discolouration. As a result of humidity from the substructure, efflorescence and staining can occur. Subsequent treatment of the set joint by scrubbing and cleaning with extremely diluted, acidic cleaning agents has proven to be effective. Water should be applied to the joint beforehand. On walls, work from top to bottom, and on floors, puddles should be avoided. Servoperl royal schnell is a cement-based product and is therefore not absolutely resistant to aggressive cleaning agents and to water with high chlorine content.
Clean up
Allow the grout to firm up in the joints. Check for firmness by touching the grout with your finger. If the grout will transfer wait adequately and test again. No transfer indicates beginning of clean-up. Wet your grout sponge in cool, fresh water and wring it out. Do not use over saturated sponge. Loosen the grout on the tile surface by moving the sponge in circular motion across the tiles. Then use the grout sponge to tool the joints. Wipe diagonally across the tiles to remove grout residue/film. Use each side of the sponge once. Rinse, completely, wring out and repeat the process. Change your cleaning water frequently.
*Contact Kiesel technical department for further instructions and guidelines.

Approx. 0.35 kg/m² for 15 cm x 15 cm tiles.
Approx. 0.50 kg/m² for 10 cm x 10 cm mosaic.
Approx. 1.00 kg/m² for 5 cm x 5 cm mosaic.

Approximate Coverage table per 11 lbs. bag.

Clean tools immiedetelly with water.