Solvent-free, very low emission, two-component, polyurethane resin adhesive for the installation of LVT, PVC coverings in highstress and high temperature areas, rubber coverings, outdoor and other hard to adhere coverings. Okamul PU has superior bonding properties. Humidity and weather resistant after it has fully hardened.

The substrate must comply with the national requirements relevant to country for installation. The surface substrate must be sound and clean. Remove dirt, paint, oil, grease wax or any other contamination which might act as a bondbreaker.

Prime absorbent, porous and dusty substrates with Okapox GF. Level uneven areas with Servoplan leveling compounds. Use Servoplan S 111 leveling compound for industrial (fork lift traffic) areas.

Empty entire hardening fluid (part B) into the main container of part A component. Mix the two components together thoroughly with an electric mixer until the mixture is without streaks. Repot and stir again.

Use an appropriate notched trowel to apply Okamul PU onto the substrate. On very smooth substrates we recommend to use a fine pointed notch trowel to avoid surplus adhesive being pressed through the joints.

Ensure full transfer of adhesive into the installed covering. Install the covering within 30 minutes and roll down firmly. Repress after approx. 2 hours. Do not allow product to form a skin. Once this occurs disgard remaining product.

Only for qualified installers.

Clean tools immediately with Bakit RT cleaning wipes.