The factory-produced fibreglass sound deadening trackKiesel Ki 880 Eco Sound is laminated with PE film on both sides. For use with minimal installation heights and maximum sound insulation. Specially for renovation in residential and commercial buildings when only low installation heights are available. Simple to process and safe to affix due to the factory-applied self-adhesive overlap.

For all clean, dry and load-bearing substrates. The substrate must be permanently dry. In individual cases, performing building waterproofing to protect against rising damp from the floor sheet beforehand may be necessary. If significant unevenness and cracks are present, the substrate must be prepared in accordance with valid standards and publications. Any cracks present must be sealed via force fitting and the primed areas are levelled with suitable Kiesel Servofix and Servoplan screeds.

Lay the sound deadening trackKiesel Ki 880 Eco Sound end to end in the room and tightly seal with the self-adhesive overlap part. The cuts can be made using scissors or trapezoid knives. On raised components, the sound deadening trackKiesel Ki 880 Eco Sound can be pulled up, or alternatively self-adhesive Kieseledge insulation strips can be affixed to the track.

Kiesel Ki 881 Eco Sound Mesh must then be laid with the prescribed minimum overlap (≥ 5 cm). The roll tension should preferably be directed towards the substrate.

After completion of preparation work, the rapid hardening flowable cement screed Servoplan E 600 is installed with a minimum layer thickness of 25 mm. Servoplan E 600 must be laid with tiles on the following day, or within 3 days at the latest. For elastic and textile floor coatings, Okatmos® DSG requires two work steps: it must be primed and used for filling in this period. If parquet floors are laid with SMP adhesives, the substrate must be primed with Okamul PU-V schnell (“rapid”) in two work steps within the previously mentioned period. The instructions in the Servoplan E 600 technical data sheet must be followed.